Our Blog

11

Inspecting homes built in the 80's

posted on
Inspecting homes built in the 80's

Inspecting homes built in the 1980’s

A 1980s home looks neither new or old—but in-between. Also, unlike mid-century and ‘70s houses, there is no clearly defined retro-style for the eighties popularized in movies and design magazines yet. Although it was a prosperous time overall, a million fewer houses were built than during the the peak of household formation for baby boomers in the seventies. Here’s what to look for if you are considering buying a 1980s home:

 

✦ Floor Plan - The average home is only a little smaller than new homes today, and the master bedroom suite and split floor plan became pretty much a standard over this decade, if not quite as spectacular as now. The eighties was also when the walls between the kitchen and the rest of the house began to come down.

 

✦Energy Efficiency - Wall and attic insulation R-value was about three-quarters of the standard today and double-pane insulated windows were installed in many, but not all, homes. The concept of carefully sealing the envelope of the house from air leakage for energy conservation was still not a big concern. 
Some of this may have been upgraded over the years, but it’s a good idea to take a peek at the condition of the insulation in the attic if you can, observe how well the doors and windows are sealed, and ask the seller to provide a few recent utility bills. 

 

✦Foundation and Exterior Walls - Most eighties homes are concrete slab-on-grade, with a thickened edge that served as a foundation. A site dictates the foundation type to a certain extent, however, and sloping sites often required a combination of a concrete block stem wall on the more sloping part of the ground under the home and slab-on-grade on the flatter areas of the site.


Over the 30-plus years of the home’s existence, soil erosion will take its toll on a sloping site as the soil slowly migrates downhill. Look for tell-tale stair-step and diagonal cracks, especially on the down-side of slopes, indicative of settlement, along with areas where the base of the foundation is beginning to become exposed. Other factors, such as expansive clay in the soil under the home, can also cause foundation distress over time.

 

Any older home will accumulate a few cracks from minor settlement and the natural expansion and contraction of the structure through the temperature changes of the seasons, and they are not a reason to be concerned. What you should look for are cracks larger than about 1/8” across (that you easily can stick two quarters into) and/or that have differential (one side is kicked-out higher than the other). Differential is usually the result of significant movement. 

 

✦ Plumbing - Although copper water supply pipe was standard, a flexible gray, plastic pipe called polybutylene became a popular and less-expensive alternative for builders during the ‘80s. It went by the acronym “PB” and was considered a wonder of new technology at the time. Unfortunately, there were recurring leakage problems at the crimp-type pipe connections early in the use of the new pipe. This was resolved by the manufacturers, but it was later discovered that the composition of the plastic was also flawed, and it could develop micro-fissures after about 20 years of service. The fissures would eventually pop open, and class-action lawsuits over the defect followed. Many homeowners received settlements for pipe replacement, but the period for filing a claim has ended and PB is no longer manufactured or approved by the plumbing code.

 

✦Electrical - The good news is that all homes built in the 80s have modern 3-slot, grounded receptacles and the electrical system is very similar to today’s equipment. GFCI (Ground Fault Circuit Interrupter) shock protection was required for bathroom and exterior outlets, and also phased in for outlets near the kitchen sink later in the decade. To learn more about GFCIs, see our blog post “Why does that wall plug have push-buttons in the middle?”

 

✦HVAC - This system has likely been replaced at least once by now, but it is also possible that it is the original system. Because the components of a heating and air conditioning system may have been changed out at different years and evaluating the condition of the ducts require crawling around the attic, wait for a thorough evaluation by your home inspector on this. But definitely take a look at both the interior and exterior units. If they are rusty and look really old, they probably are.

 

✦ Roofing - The average life expectancy of a roof is 20 years and, since the home is now 30-plus years old, the roof has been replaced at least once by now. To learn what clues to look for when trying to determine the condition of the roof, see our blog “How can I tell if the house needs a new roof?” Your home inspector will take a look at the roof up-close, but there’s plenty you can observe looking up at it from the yard.

 

✦Overall Condition - Houses run the gamut from rough shape to recently updated. For tips on evaluating one that needs repairs, see our blog “Should I buy a fixer-upper?”; and, if the house has been remodeled by an investor for resale, find out more at “What are the common problems to look for when buying a ‘flipper’ house?”

 

✦ Neighborhood and Value - These are things your realtor can help you with. But if you are ready for a ‘80s home, this era offers a combination of good value for your dollar and reasonably modern construction and technology.

 

 Minneapolis Home inspection Companies | Mold Inspections Companies | Radon Inspection Companies | Home inspections

Categories: Inspection | Tags: minneapolis home inspection companies , mold inspections , radon inspections , saint paul home inspection companies | View Count: (21) | Return

Our Pricing

Home Inspections

100-3,000 Square Feet:

3,001-4,000 Square Feet:

4,001-6,000 Square Feet:

Townhome Under 3000 Sq Ft

Condo Under 3000 Sq Ft

$395.00

$490.00

$590.00

$330.00

$300.00

Specialty Inspections

Radon Inspection:

Mold Inspection:

Sewer Scope Inspection

$150.00

$150.00

$250.00

* Mold/Radon Sewer Inspection Prices are Valid Only If Complete Inspection is Ordered. Prices for Inspections within 150 mile Radius of Minneapolis - St. Paul. .50 cents per mile over 150